Drainage Problems in Mill Valley
Drainage Issues in Mill Valley show up as water getting into your home or building, and can cause basement flooding, wet crawlspaces, mold, landslides, mud in the yard, and flooding or pooling of water in the yard. Driveway drainage problems in Mill Valley may include water getting into the garage, into the home, and unwanted puddles on the concrete driveway. If you notice signs of drainage problems in your Mill Valley property, we will be pleased to come take a look at it, with no obligation. Just give us a call at (510) 215-3636 to set up a professional estimate.
Drainage Contractors
Drainage construction in Mill Valley often involves drainage design in order to protect basement from flooding, dry out wet crawlspaces, avoid mudslides, protect retaining walls, and stop the yard from flooding. Water under a house or home can be very damaging, causing mold, bad smells, mildew, and dry rot. Drain repair and drainage repair may involve installation of a French drain or French drains, and sometimes it is necessary to install sub drains, and a catch basin and sump pump to divert water from low areas under a home. Rainwater and stormwater should run off the roof through gutters and downspouts, onto concrete tile or through grates then into the French drain, through piping and find its way to appropriate storm drains.
As competent drainage contractors we offer professional estimates in Mill Valley, provide advice on drainage design, provide an estimate or bid for your drainage job, perform the work quickly and efficiently, with minimum intrusion on your lifestyle. Most drainage problems are too much for the do-it-yourself project. They often involve structural design, concrete pour into wood forms, underground drainage, and more.
Actual drainage job completed in Mill Valley:
Here is one of many examples of a drainage construction project we completed on Green Glen Way, in Mill Valley:
We will construct a drainage system along a 20 feet long portion of the rear and the entire left side of your home.
The drainage system consists of two pipes in a rock filled trench. One is perforated, to collect sub-surface water and the other is non-perforated, to collect water from the roof downspouts. At the upper end or start of the perforated pipe, a clean-out will be provided so the pipe can be tested or cleaned as necessary.
The starting depth for the perforated pipe will be 3 feet or below the grade of the soil under the house and both the perforated and non-perforated pipe will fall at least 1/8 inch per foot for the total length of the system to the point of discharge.
The perforated pipe will be installed on top of a bed of gravel, two inches deep, with the perforations pointed down. The trench will then be then backfilled with drain rock. The rock we recommend is Class I, Permeable Type A drain rock per the California State Specifications. The drain rock is clean gravel that varies in size from 1/4 to 1/2 inch.
The trench will be a minimum of 12 inches wide. This permits a four-inch blanket of rock on each side of the four-inch perforated pipe.
The system will daylight onto the driveway.
We will remove and replace the existing brick and wood deck boards as necessary along the rear side.
We will extend a 4-inch solid discharge pipe across your driveway and down the front slope to the street. We will remove and replace a strip of concrete across the driveway as necessary.
We will form and pour a 12-inch deep curb wall in the sub-area along an 8 feet long portion of the foundation adjacent to the left front corner.
Call Ward Construction today.
In Mill Valley we specialize in drainage.